Middleby Marshall PS629G Series, Owner'S Operating & Installation Manual

Page: 19 / 52

SECTION 2
INSTALLATION
19
Please Note: There are now two “stand off” plate
air vents that must be installed in the field.
C-channel brackets are installed in the vertical plane
using existing screws to support plate air vents, using
the upper and lower Key Hole openings in the
C-channels. The plate air vents are identical and once
installed will allow ample amounts of air through the
cooling fan mounted on the rear side of the oven by
keeping the oven away from the rear wall.
III. ELECTRICAL CONNECTION
INFORMATION FOR PS629G-SERIES
OVENS
WARNING
Authorized supplier personnel normally
accomplish the connections for the ventilation
system and electric and gas supplies, as
arranged by the customer. Following these
connections, the factory-authorized installer
can perform the initial start-up of the oven.
Check the oven data plate (Figure 17) before making
any electric supply connections. Electric supply
connections must agree with data on the oven data
plate.
NOTE: The electric supply installation must satisfy the
requirements of the appropriate statutory authority,
such as the National Electrical Code (NEC),
ANSI/NFPA70, (U.S.A.); the Canadian Electrical
Code, CSA C22.2; the Australian Code AS/NZ5601; or
other applicable regulations.
A fused disconnect switch or a main circuit breaker
(customer furnished) MUST be installed in the electric
supply line for each oven; it is recommended that this
switch/circuit breaker have lockout/tagout capability.
The electric supply connection must meet all national
and local electrical code requirements. Copper is the
recommended material for the electrical supply
conductors.
INTERNATIONAL CE PLATE
DOMESTIC PLATE
Typical Oven Data Plate