Manufacturing Test
UG0617 User Guide Revision 4.0
42
8
Manufacturing Test
The RTG4 Development Kit contains a manufacturing test program that can be run to verify board
functionality. The program contains a list of options that can be run as diagnostics. After setting up the
TeraTerm and powering up the board, the test options are displayed. Any test option can be selected to
verify board functionality. For more information, refer to
Figure 28,
page 47.
Before testing the RTG4 Development Kit:
•
Download the RTG4_DEV_KIT_MTD.stp file from
http://soc.microsemi.com/portal/default.aspx?r=17&p=f=RTG4_DEV_KIT_MTD
.
•
Download and install the FTD drivers from
http://www.ftdichip.com/Drivers/D2XX.htm
.
8.1
Software Installation
The RTG4 Development Kit has an on-board embedded FlashPro5 (FP5) programmer supported the by
FlashPro version 11.5 or later. An external programmer is not required.
The following are the system requirements for FlashPro:
•
Windows 7 Professional or later 64-bit operating system
•
500 MB disk space
For more information about system requirements, see
http://www.microsemi.com/products/fpga-
soc/design-resources/programming/flashpro#software
.
Download and install FlashPro version 11.5, available at
http://soc.microsemi.com/download/reg/download.aspx?p=f%3dFlashProv11_5
. Then, connect one end
of the USB cable (mini USB to Type A USB cable) to J47, and connect the other end to the USB port. If
the cable is already connected, unplug the cable and connect it again. Once the USB cable is connected,
the PC will detect the on-board embedded FP5 and install the drivers.
Note:
Installing drivers is a one-time process.
8.2
Hardware Setup
The following table lists the jumper settings required to run the manufacturing test. For more information,
see
Figure 3,
page 6.
Table 17 •
Jumper Settings for Manufacturing Test
Jumper
Description
Pins
Settings
J28
PHY Config jumper
1-2
Short
J32
PROG-SEL-JUMPER
1-2
Short
J27
JTAG/SPI SEL
1-2
Short
J23
VPP power jumper
1-2
Short
J17
12v power switch jumper
1-2
Short
J26
Bank 2 power jumper
1-2
Short
J21
Bank 7 power jumper
1-2
Short
J16
VDD power
2-3 for 1.2 V
Short
J19
FMC 1 power
1-2
Short
J11
FMC 2 power
1-2
Short
J33
1P2V_SERDES_IO jumper
1-2 and 3-4
Short
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from