Panel Functions 145
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex
logiJET TC8
Edition 1.2
Hints on adjusting the position:
This function is used to change the cutting position of the optional cutter:
Adjusting causes a shift of the cutting position relative to the printer
detected gap position (i.e. relative to the perforation or the start of the
label, compare the following figure).
Cutter
1. Drucken
2. Drucken Ende
Feed,
then cut
Front
print head
Page, printed
Setting range for the
cutting position
(Offset: 0 up to +10.7mm)
(Offset: 0 to -10.7 mm)
Please note:
Changing the SyncOffset has an effect on the cutting position, too.
For further information see section 7.4 Adjusting the Zero Position of
the Material Transport.
