MicroNet SP5582HTM, User Manual

Page: 57 / 122

56
Select an alarm type, “Normal close” or “Normal open,” that corresponds with
the alarm application.
Alarm Output
Define alarm output signal “high” or “low” as the normal alarm output status
according to the current alarm application.
Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when the alarm is
triggered. All options are listed as follows:

Enable Alarm Output
Select the item to enable alarm relay output.

IR Cut Filter
Select the item and the camera’s IR cut filter (ICR) will be removed (on)
or blocked (off) when alarm input is triggered.
Note:
The IR Function (Refer to 6.5.5 IR Function ) could not be
set as <Auto> mode if this triggered action is enabled.

Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP
and/or E-Mail when an alarm is triggered.

Upload Image by FTP
Select this item and the Administrator can assign a FTP site and
configure various parameters as shown in the figure below. When the
alarm is triggered, event images will be uploaded to the appointed FTP
site.