S
ET
U
P
C
OMMANDS
Analysis Conditions on page 3 - 14
Report Options on page 3 - 20
Communications on page 3 - 34
System Options on page 3 - 38
Use the
Set Up
function to:
n
Edit a
Set Up
group
n
Copy the values of one
Set Up
group to another one, then modify the values
n
Reset the values of a
Set Up
group to a default set
A
Set Up
group is a user-defined set of conditions to perform analyses, report data, and transmit
data. It also contains system options such as instrument ID.
Set Up
groups contain the following
condition sets.
Function
Description
Analysis Conditions
Specify the evacuation rate, evacuation time, free-space
measurement, saturation pressure, target relative pressures, and
analysis mode.
Report Options
Specify the report destination, the starting and ending points for
collecting data to calculate surface area, the surface area
calculations to report BET multipoint, Langmuir, BET single-point,
t-method report options, the area of the adsorbate gas molecule, and
the density conversion factor to use for calculating total pore volume.
Communications
Specify transmission parameters and internet criteria.
System Options
Specify criteria for the system (date, time, etc.) and for
Set Up
groups
(sample ID, sample mass, etc.).
Set Up Function
Up to 10
Set Up
groups may be defined. Each group has a number, 0 to 9, associated with it.
When an analysis is performed, the keypad window displays a prompt to enter the number of the
Set Up
group to be used for the analysis. The default
Set Up
groups 0 and 4 through 9 set to
factory default values.
n
Set Up
group 0 has been predefined with a sample identification (predefined with factory
defaults).
n
Set Up
groups 1 through 3 also have been predefined.
n
Set Up
groups 4 through 9 are unused.
All values in the
Set Up
groups can be edited or reset back to factory defaults.
Set Up Commands
Gemini VII Keypad Operator Manual
239-42801-01 (Rev E) — July 2021
3 - 3