Microframe Corporation
11
604 South 12
th
Street
Broken Arrow, OK 74012
800-635-3811
www.microframecorp.com
Series 3500
Finding Lost Pagers
To find lost pagers, you can press “1249” and “SEND”. This will cause the
pagers to flash, vibrate, and beep for 3 minutes. (The beeping will start after
10 seconds.)
Programming the Base Station
The base station is used to program the basic pager identities. These
options should be set at the factory. Here
’s how to change them.
Button operation while in program mode:
PROG
– Enter / Hold to save
DOWN ARROW
– Exit
UP ARROW
– Selects next option
Program mode will automatically exit after about 15 seconds without activity.
First place the base station into program mode by holding down the
“PROG”
and UP arrow simultaneously until it beeps (about 3 seconds). You will see
“STNO” on the screen. Press the up arrow to cycle through the available
options:
STNO
– Starting Pager Number
BASE
– Base Identity
ALT
– Reserved
ALTT
– Reserved
When you have selected the option you want, press
“PROG”.
Setting Starting Pager Number
You can change the starting pager number for this base station. For
instance, starting with pager 31 for a secondary base station.
Put the base station in program mode and select the
“STNO” option. Press
“PROG”. Use the up/down arrows to set your desired starting number. Hold
down the “PROG” button to save (about 3 seconds). Press “Down” to exit.
See
“Renumbering the Pagers” to update your pagers.
Setting The Base Identity
The identity for this base station must match the transmitter. By default this
base has an ID of
“050”, which matches the transmitter’s Base ID of
“0500000”.
Put the base station in program mode and select the
“BASE” option. Press
“PROG”. At the “SB1” option, press “PROG” again. Use the up/down arrows
to set your new Base ID. Press and hold the
“PROG” button to save your
changes. Press
“Down” to exit.
See
“Programming the Pagers” to update your pagers.
Caution
The pager is made up of precision elements. Avoid water and high
temperature. If the pager is not working properly, do not dismantle or repair
it yourself. Call Microframe for technical service.