Microframe Corporation
8
604 South 12
th
Street
Broken Arrow, OK 74012
800-635-3811
www.microframecorp.com
Series 3500
Installation
1. Connecting the power adapter
a. Place one wire from the adapter under one of the screwdown terminals and the other wire under the
other screwdown terminal. Refer to the wiring diagram decal on the back of the display.
b. Plug in the power adapter and check the display for proper operation.
2. Mounting
a. Microframe displays can be hung on the wall similar to a picture frame.
b. There is a keyhole in the back of the display for this purpose.
Operation
If you purchased this Display for use with a MultiPage Transmitter, you should be able to simply plug in the
display and then enter and delet
e numbers as specified in the “MultiPage Operation” section. If you are using this
d
isplay with another transmitter, please read "Using the Display with Alternate Transmitters” that is located on the
following page.
Configuration
The display configurations fall into two basic categories. The first is "Display Communication Settings," and the
second is "Display Behavior Settings." However, under normal circumstances, you will not need to change the
display configuration.
•
Display Communications Settings
The display comes from the factory ready to communicate with a MultiPage Transmitter (Base ID 0500000,
Baud Rate 1200). The display will intelligently communicate with other settings by doing the following:
Press the button on the back of the display one time. The display will show vertical bars. Next, page Pager
number 1 with a beep type of 2 and message 7337. The display should change to horizontal bars to signify
that it has learned the transmitter identity (Base ID and Baud Rate). If the display does not receive a valid
transmission within 90 seconds, it will show
"
EE".
•
Display Behavior Settings
The display's behavior can be changed by sending special codes to Pager 9999. All codes are indicated by
the form XX_XX or XX_XXXX where "_" is a space. Use the [SETUP] key to insert a space in a message.
There are five settings that can be changed using the 9999 command as seen below.
•
Mode Settings
- The display has two possible Modes:
Mode 1 displays the messages sent to a specific vibrating pager.
Mode 1) To program the display to show all messages sent to Pager 300. Send a page to Pager 9999 with the
message “00_0300.”
NOTE: You must use the [SETUP] key to insert the space in the message between 00 and the Pager
number. The Display will now show all messages sent to Pager 300.
Mode 2 displays all pager numbers paged by the transmitter.
Mode 2) To program the display to show all pages sent by the transmitter, send a page to Pager 9999 with the
message
“00_0000.”
Visual-Pager® Display Detailed Operation
