Orbit II Disc Copier Reference Manual – Revision K
25
Section 6: Basic Orbit II Operations
Orbit II was designed to be as easy to use as an office copier for paper documents. Making copies of a
master Disc takes only a few simple steps; load the number of blank discs you want to copy, select
Copy
DISCtoDISC ?
by pressing the
Yes
key, insert your master in Orbit II’s DVD Reader, and press the
Yes
key again. Orbit II will copy the master disc on to blank discs until its Input Hopper is empty. Because all
operating mechanisms are fully enclosed; you can add discs to the Input Hopper, remove discs from the
Accept Basket, or remove Discs from the Reject side at any time. Your master disc can be a CDROM, CD-
R or CD-RW disc. There are three Orbit II operating modes,
Copy?,
Copy &
Compare?
, and
Compare
Disc?.
The
Copy
mode has three options, Disc to Disc, Disc to HDD and HDD to Disc. The Orbit II has an
internal hard drive that stores up to 10 different images.
There are two different ways you can set up your Orbit II, depending upon how you intend to use it. If
Ask
Quantity?
is turned on, Orbit II will ask the operator how many discs should be processed for each job. In
this operating mode you can leave a stack of blank discs in the Input Hopper. Orbit II will always provide
the requested number of discs, even if some discs are rejected during the job. If
Ask Quantity?
is turned
off, Orbit II will not request a quantity from the operator. Orbit II will expect the operator to place the proper
number of discs in the Input Hopper before starting the job. If there are rejects, and a specific quantity of
discs is needed, the operator will have to add additional discs during the job, or set up another job when
the first job is complete. See Section 7 for additional details on the
Ask Quantity?
option.
6.1 Copy DISCtoDISC
This Orbit II operating mode is the easiest to use because it is the main menu selection that Orbit II
presents when it completes its power on self-test. A “copy only” operation is the most common form of disc
duplication. In
Copy ?
mode
Orbit II does not verify the content of each data sector recorded. The
example shown below assumes
Ask Quantity?
is turned on.
To initiate a
Copy ?
operation:
•
Make sure there are enough discs in the Input Hopper.
•
Press the
Yes
key at the
prompt.
•
When the
prompt appears, use the
Yes
and
No
keys to set
the required number of discs in Orbit II’s counter. Pressing the
Yes
key accepts the number
above the underline cursor, and tells Orbit II you are ready for the next operation. Pressing the
No
key increments the number above the underline cursor. (If you accidentally press the
Yes
key at the “10s” digit and move to the “1s” digit before you are ready, you can get the cursor
back to the “10s” digit by pressing the
No
until the “1s” digit changes from “9” to “0”.)
•
When the DVD Reader tray opens, place your master in the DVD Reader tray and press
Yes.
•
Orbit II will copy the master disc on to the blank discs until the requested number of discs are
accepted.
•
You can add discs to the Input Hopper, remove discs from the Accept Basket, or remove Discs
from the Reject side at any time.
Copy ?
Quantity? 00
