Orbit II Disc Copier Reference Manual – Revision K
18
Loading CD-Rs (cont)
There are two ways to control how many copies Orbit II makes. If
Ask Quantity?
is turned off, you control
the number of discs produced during each job by placing the appropriate number of blank CD-Rs or CD-
RWs
in the Input Hopper. Orbit II stops copying when its Input Hopper is empty. Remember that there is always
the possibility of a reject. If you need a specific number of copies, place one extra blank disc in the Input
Hopper. If
Ask Quantity?
is turned on, you control the exact number of copies produced by setting Orbit
II’s counter at the start of each job. (Refer to Section 7 for details.)
Orbit II’s Input Hopper can hold a maximum of 50 CD-R or CD-RW discs. Always load the first 5 or 6 CD-
Rs on the Singulator Plate and Rear Support Ledge. The discs will be horizontal if loaded properly.
If the duplication job requires more than 5 or 6 CD-Rs, load the remaining CD-Rs, leaning against
the Stepped Guide Rod. You can load up to a maximum of 50 CD-Rs in the Input Hopper.
The Singulator will separate the bottom disc from the stack and feed it into the CD-R Writer. The horizontal
discs will move down. The stack that is leaning against the Stepped Guide Rod may not drop a disc each
singulation cycle, but there should always be at least two discs in the horizontal group.
First 5-6 CD-Rs
First 5 or 6 CD-Rs
