Micro 8008-04, Installation Instructions Manual

Page: 8 / 24

P.8
8008_inst.7/7/04.qx
(BLACK NUT)
Adjusts both stage 1 and stage 2
(GRAY NUT)
Adjusts stage 2 only
(GREEN)
1st stage indicator
(RED)
2nd stage indicator
+ 12vDC
(-) armed output (grounded only when the alarm is armed)
Warning zone
Instant trigger zone
LED: STATUS INDICATOR
LED: STATUS:
Off Alarm Disarmed
Flashing Slowly Alarm Armed
Flashing Rapidly (Alarm Disarmed) Self-Arm Countdown
Flashing Rapidly (Alarm Armed) Intrusion Confirmation
Flashing Rapidly (Ignition “ON”) Anti Hi-Jack Countdown
On Solid Valet Mode
CONNECTION: Mount Where Desired And Plug It In.
DUAL-STAGE SHOCK SENSOR: (DUAL-ADJUSTMENT)
This alarm system comes equipped with a dual-stage shock sensor. The first stage is a warning zone which if trig-
gered will emit a series of siren chirps. The second stage is an instant trigger zone. Each zone can be independantly
adjusted for appropriate sensitivity.
ADJUSTMENT: When adjusting this sensor, it is recommended to set the screw at the half rotation first, then
adjust the sensitivity of the “pre-warn” circuit followed by the adjustment of the instant trigger zone.
NOTE: If the sensor zone is triggered 5 times while the alarm is armed, the sensor zone will be bypassed. This
zone will reset when disarming the alarm.
MOUNTING: Correct Placement Is Essential For Proper Operation. The Sensor Should Be Mounted To A Rigid Wire
Harness Under The Dash Using Plastic Cable-Ties Or Directly To The Firewall Using Double Sided Tape. Do Not Mount
With Screws And Do Not Place Under The Hood, This Unit Is Designed For Interior Use Only.
CONNECTION: Plug It In.
Red Wire: Constant (+)12 Volts
Black wire: (-) armed output (grounded only when the alarm is armed)
White Wire: Warning Zone
Blue Wire: Instant Trigger Zone