Micro 8008-04, Installation Instructions Manual

Page: 10 / 24

P.10
8008_inst.7/7/04.qx
PROGRAMMABLE JUMPER PINS SETTINGS:
Pin # Pin-In Pin-Removed
——- ——— —————-
1 Current Sensing ON Current Sensing
2 Passive Arming Active Arming
3 Passive Locking Passive Locking OFF
4 Normal Door Trigger 60 Second Door Trigger
Arming Delay For Dome-Lights
5 Ignition Auto-Lock ON Ignition Auto-Lock OFF
6 1 Second Door-Lock pulse 3 Second Door-Lock pulse
IMPORTANT NOTE: If Any Of The Jumper-Pin Settings Are Changed It Is Absolutely NECESSARY To Power-Down And
Power-Up The Unit Again. If This Is Not Done The Unit Will NOT Register The Change.
PROGRAMMING: REMOTE CONTROLS & FEATURE SETTINGS
This Is A Code-Learning System, The Alarm Will Learn The Remote Control(s). Therefore Programming New Or
Additional Remote Controls Is A Simple Procedure. There Are Many Settings That Can Be Programmed Into The
System.
ENTERING CODE-LEARNING & PROGRAMMING MODE:
1. Turn The Vehicle’s Ignition To The “ON” Position.
2. Press The Valet/Override Button 5 times.
• The Siren Will Emit A Long Chirp & The LED And Parking Lights Will Light Solid To Confirm Entry Into
Code-Learning & Programming Mode.
3. At This Point The Programmer Can Either Code-Learn Remote Control(s) Or Change
Programmable Feature Settings.
NOTE: If At Any Time 7 Seconds Elapse Without Input, The Alarm Will Automatically Exit Code-Learning &
Programming Mode
CODE LEARNING REMOTE CONTROL(S):
Once In Code-Learning & Programming Mode:
1) PRESS THE “LOCK” BUTTON OF EACH REMOTE CONTROL THAT YOU WISH TO
PROGRAM.
**** (OR) ****
• A Maximum Of 4 Remote Controls Can Be Programmed.
• The Siren Will Chirp & Parking Lights Will Flash To Confirm Each Time A Remote Has Been Learned According To
The Number Of The Remote Programmed.
EXAMPLE:
1st Remote Programmed = 1 Siren Chirp & 1 Light Flash
2nd Remote Programmed = 2 Siren Chirps & 2 Light Flashes
3rd Remote Programmed = 3 Siren Chirps & 3 Light Flashes
4th Remote Programmed = 4 Siren Chirps & 4 Light Flashes
2) IT IS ALWAYS ADVISABLE TO FILL ALL FOUR OF THE MEMORY SLOTS:
A) If You Only Have 1 Remote Control Program It 4 Times.
B) If You Have 2 Remote Controls Program Each One Twice.
3) THERE ARE 2 OPTIONS WHEN YOU ARE DONE CODE-LEARNING REMOTE CONTROLS:
A) If The Programmer Does NOT Need To Change Any Feature Settings Then Exit Code-Learning & Programming
Mode By Turning OFF The Vehicle’s Ignition. (Turn Off The Key)
B) If The Programmer Needs To Change Programmable Feature Settings Please Refer To The “Programming
Feature Settings” Section Below.
NOTE #1: The Remote Controls Provided With This System Are Already Programmed And Ready For Use. Programming
Is Necessary Only For New Or Replacement Remote Controls.
NOTE #2: Every Time A New Remote Control Is Programmed The Unit’s Memory Is Cleared. This Means That Any
Remote Control(s) Previously Programmed In The Memory Have Been Erased And Now HAVE TO BE REPRO
GRAMMED.
SPECIAL NOTE: If At Any Time 7 Seconds Elapse Without Input, The Alarm Will Automatically Exit Code-Learning Mode.