Micro Matic JOETAP JT-CTMG, Installation, Use And Maintenance Manual

Page: 16 / 28

16 | JOETAP
®
BARISTA INSTALLATION, USE & MAINTENANCE GUIDE 855-4JOETAP / (866) 327-4159 / MICROMATIC.COM
PROCEDURE
• Increase Level of N2 infusion (thicker head and more dramatic cascading effect).
– Turn the N2 regulator adjustment screw clockwise.
– Hold the gas in button for a full second.
• Decrease Level of N2 infusion (thinner head and less dramatic cascading effect).
– Turn the N2 regulator adjustment screw counterclockwise.
– Hold the gas out button for a full second.
– If the N2 Generator turns ON, wait for it to build pressure and automatically turn OFF.
– Hold the gas in button for a full second.
NOTE: The N2 regulator adjustment screw is sensitive and may require very small turns/
adjustments to achieve desired N2 infusion specification.
ADJUSTING BRIX WITH VOLTAGE: GENERAL INFORMATION
• The voltage regulator controls the voltage that is supplied to the peristaltic pump. Voltage
supplied to the pump determines how fast the pump motor spins (
RPM
) and how much
liquid can be displaced (flow rate) for a given tubing diameter and gearbox.
• The voltage regulator should be set no lower than 12V.
– If the proper flow rate cannot be achieved by adjusting voltage within 12-22V, a tubing
change or gearbox change may be necessary.
– If flow rate is too high at 12V, a smaller diameter tube and/or lower
RPM
gearbox must
be used.
– If flow rate is too low at 22V, a larger diameter tube and/or higher
RPM
gearbox must
be used.
NOTE: see Peristaltic Pump Package Guide (section 6) to determine optimal tubing/gearbox
package.
PROCEDURE
• Using a flathead screwdriver, gently pry away the clear plastic cover covering the
voltage regulator.
• Turn the water pump button OFF and the product pump button ON.
• Open either of the faucets for a full second and close it.
• Adjust the voltage regulator to the desired voltage.
NOTICE
Do not leave the product
pump button on while the
water pump button is off for
extended periods of time,
as this will cause excessive
wear on the equipment and
could result in pre-mature
product pump maintenance
service