12
| JOETAP
®
BARISTA INSTALLATION, USE & MAINTENANCE GUIDE 855-4JOETAP
/
(866) 327-4159
/
MICROMATIC.COM
FILL CHILLER WATER/ICE BATH
• Fill the water/ice bath with 2 gallons of water.
– Water/ice bath should be filled using sight glass tube on the front of the chiller.
NOTE:
Sight glass tube accessed by opening dispenser door and removing two Phillips
head screws from white plastic shroud covering the face of the chiller.
• Once the water/ice bath is full, water should begin flowing through the ice/water bath
overflow drain line. If not, continue filling slowly until water begins to flow.
INSTALL FAUCETS
• Install faucets on the door.
– Locate one of the two included stout faucets insert into either of the sockets on the
door. Using a spanner wrench, tighten the collar on the door socket until faucet is
tight and cannot spin freely. The collar must be turned counterclockwise to tighten
the faucet. Repeat this step for the second faucet.
NOTE:
Faucet handles should be perpendicular (at 12 o’clock) in relation to the
countertop once tightened.
– Locate the two black tap handles and thread them onto the handles of the faucets.
– Ensure that both faucets are closed (handles pointed up and perpendicular to
the counter).
PLUMB WATER SUPPLY LINE
•
Plumb water line to the unit following all criteria outlined in Installation Location
Requirements (section 5).
– Plumb water line with an in-line shutoff, back flow prevention device and water
filter (if the plumber has not already done so), in accordance with criteria outlined
in Installation Location Requirements (section 5) and in conformance with national
and local codes.
– If applicable, install Eltek® Water Block in-line.
• Upon turning in-line water shutoff valve to the ON position, observe the unit and all
connection points for leak(s).
– If there are any apparent leaks, immediately turn OFF and disconnect the water
supply, turn OFF and unplug the unit, and fix the water leak(s) before proceeding.
NOTE:
Ensure the unit is fully reassembled to the manufacturer’s specifications before
reinstalling and reestablishing water and power connections.
ELECTRICAL CONNECTIONS
• Plug the unit into electrical outlet meeting all electrical requirements outlined on unit
name label and in Installation Location Requirements (section 5).
WARNING
All wiring and plumbing must
conform to national and
local codes.
WARNING
JT-CTMG must be electrically
grounded to avoid possible
fatal electrical shock
or serious injury to the
operator. 120V JT-CTMG
power cord is equipped
with a 3-prong plug. If
supply cord is damaged it
must be replaced by the
manufacturer or its service
agent or a similarly qualified
person in order to avoid a
hazard.
WARNING
Risk of electrical shock.
Connect to a properly
grounded outlet only.
