MICRO-EPSILON ILD2200-10, Instruction Manual

Page: 66 / 72

Page 66
Warranty
optoNCDT 22xx
Warranty 11.
All components of the device have been checked and tested for perfect function in the factory. In the unlikely
event that errors should occur despite our thorough quality control, this should be reported immediately to
MICRO-EPSILON. The warranty period lasts 12 months following the day of shipment. Defective parts, except
wear parts, will be repaired or replaced free of charge within this period if you return the device free of cost to
MICRO-EPSILON.
This warranty does not apply to damage resulting from abuse of the equipment and devices, from forceful
handling or installation of the devices or from repair or modifications performed by third parties.
MICRO-EPSILON will specifically not be responsible for eventual consequential damages.
No other claims, except as warranted, are accepted. The terms of the purchasing contract apply in full.
MICRO-EPSILON always strives to supply the customers with the finest and most advanced equipment. De-
velopment and refinement is therefore performed continuously and the right to design changes without prior
notice is accordingly reserved. For translations in other languages, the data and statements in the German
language operation manual are to be taken as authoritative.
Service, Repair 12.
In the event of a defect on the sensor, sensor cable or controller:
If possible, save the current sensor settings in a parameter -
set, see ILD2200 Tool, Measurement / Configuration menu, in
order to load the settings back again into the controller after
the repair.
Please send us the effected parts for repair or exchange.
-
In the case of faults the cause of which is not clearly identifiable,
the whole measuring system must be sent back to:
MICRO-EPSILON Optronic GmbH
Lessingstraße 14
D-01465 Langebrück
Telefon: 035201 / 729 - 0
Fax: 035201 / 729 - 90
optronic@micro-epsilon.de
www.micro-epsilon.com
Decommissioning, Disposal 13.
Disconnect the power supply and output cable on the controller.
Disconnect the sensor cable between sensor and controller.
The optoNCDT22xx is produced according to the directive 2002/95/EC („RoHS“).
The disposal is done according to the legal regulations (see directive 2002/96/EC).