4
HLP-SERIES Hot Water Pressure Washer Operator's Manual
important safety instructions
WarninG:
When using this product, basic precautions should always be observed, including the following:
READ ALL THE INSTRUCTIONS BEFORE USING THE PRODUCT
WarninG: risK of
eXplosion or fire
Serious injury or death may occur
from normal sparks in the multiple
ignition sources.
Serious injury or death may occur
if system safety's are not properly
maintained.
Serious injury or death may occur
from gas leaks.
If you don't follow these instructions
exactly, a fire or explosion may
result causing property damage,
personal injury or loss of life.
. Installation of this unit including all gas piping must
comply with all local, state and national codes.
(Standards to be followed include the National Fuel
Gas Code ANSI Z223./NFPA No. 54. In Canada;
Refer to the CSA B49. Gas Installation Code).
2. Use appropriate fuel (L.P. - Gas Vapor) for the
machine you are using.
3. Do not connect gas lines to the pressure washer
before testing gas piping pressure or there may
be damage to the gas valve.
4. Do not adjust gas pressure above recommended
levels. Excessive pressure may cause damage to
the valve.
5. Liquid propane models are designed to run on
vapor propane fuel.
do not use liquid fuel.
6. Do not replace or refill L.P.-Gas tank while unit is
running.
7. If you smell gas, extinguish any open flame and test
all joints with a soap solution. If the odor persists,
turn off gas supply and call for service.
8. L.P.-Gas is heavier than air and will gravitate to the
floor. Always provide adequate floor space and
ventilation with L.P.-Gas systems and sniff floor
area for gas before operating. Do not operate unit
if smell exists.
9. Never expose a spark or flame where there may
be unburned gas present.
10. In the event of pilot outage, wait at least five minutes
to clear out any gas before relighting.
. Use only your hand to push in or turn the gas
control knob. Never use a tool. If the knob will not
push in or turn by hand, don't try to repair it; call a
qualified service technician.
2. Never leave operating unit unattended.
3. Never operate unit with L.P.-Gas tank on shelf of
the unit. Move the L.P.-Gas tank as far away from
the unit as the hose allows.
4. When servicing this machine, be especially careful
to properly shut off gas supply.
5. Operate or install the pressure washer where open
flame or torch is permitted.
6. Always operate pressure washer in a well ventilated
area free of flammable vapors, combustible
materials including dust or gases.
7. Do not allow lint or dust to collect in burner area.
18. Do not use this pressure washer to spray flammable
liquids! Flammable liquids can create fumes which
can ignite.
9. This pressure washer has multiple safety devices
which should never be altered, modified, removed
or made inoperative. If a device fails, replace
immediately with only genuine manufacturer
replacement part.
