8
HLP-SERIES Hot Water Pressure Washer Operator's Manual
WarninG: risK of burns
WarninG: risK of burstinG
WarninG: risK from
moVinG parts
Serious injury may occur from touching
the heat exchanger or vent piping. These
areas can remain hot for some time after
the pressure washer is shutdown.
. Never make adjustments to the factory
set pressures.
2. If burner fails to shut off, turn off the gas
supply and contact your serviceman.
3. Never exceed manufacturers
maximum allowable pressure rating
of attachments.
4. Do not allow any hoses to make contact
with the heat exchanger to prevent the
possibility of bursting. Avoid dragging
the hoses over abrasive surfaces such
as cement.
5. Use only manufacturer recommended
repair parts for your pressure washer.
6. In freezing temperatures, the unit must
always be warm enough to ensure there
is no ice formation in the unit. Do not
start the pressure washer without first
allowing the unit to thaw.
. Never allow any part of your body to
contact the heat exchanger or the vent
piping.
Serious injury may occur to the
operator from moving parts on the
pressure washer.
. Do not operate the unit without all
protective covers in place or make any
adjustments without shutting off the
pressure washer, relieving pressure
and disconnecting the pressure washer
from the power source. Allow pressure
washer to cool down. Never assume
the pressure washer is safe to work on
just because it is not operating. It could
restart at any time!
Serious injury may occur from a
pressure washer malfunction or
exploding accessories if incorrect
system components, attachments or
accessories are used.
Serious injury or death may occur if
attempting to start the pressure washer
when the unit is frozen.
important safety instructions
WarninG:
When using this product, basic precautions should always be observed, including the following:
READ ALL THE INSTRUCTIONS BEFORE USING THE PRODUCT
