32D1999
27
Figure 74 - Attaching Remote Receiver wires to Terminals
THTP
TP
TH
Millivolt
Valve
Pilot
OPTIONAL REMOTE RECEIVER (MILLIVOLT)
REMOTE RECEIVER INSTALLATION
DO NOT PLACE THE REMOTE IN THE FIREPLACE IF ANY OF THE FOLLOWING CONDITIONS APPLY:
• The floor of the fireplace is recessed below the fireplace opening.
See Warnings on Page 7.
• The fireplace has glass doors which when open reduces the opening width to 1
1
/
2
" or more below the stated
minimum dimensions within the homeowner’s manual.
• The floor of the fireplace is sheet metal without a brick covering.
• The remote receiver is attached but does not physically fit inside the fireplace with 2" clearance to the side
wall.
INSTALLING REMOTE RECEIVER
Connect wires according to remote receiver instructions. The female terminals should be connected to factory
attached male terminals which are located on right hand side of the burner.
See Figure 74.
NOTE: Do not let wires touch grate and/or burner.
For more details, see remote receiver instructions.
NOTICE
• Failure to follow instructions exactly will void warranty and could cause receiver to
melt.
• Failure to place remote receiver in any location within the fireplace other than
recommended location will void warranty and could cause receiver unit to melt.
NOTE: battery life decreases as temperature increases. Keep remote receiver in a low temperature
area outside of fireplace to prolong battery life.
Optional Wall Switch or
Remote Receiver
