Mod. IC
Version 01
Page 17-34
Flap open / closed
The arrow shows if which flaps is open. If no arrow is shown the machine is ready for
operation. If all flaps are closed and only one the left arrow on the display lights up, only
open one flap briefly and close it again (safety circuit for the flaps must be activated).
Subsequently this arrow goes out, the machine is ready for operation.
Conveyor speed
The conveyor speed during the cutting procedure can be pre-selected from 0 – 99
Distance of the portioning products
The distance of each entered “number of slices” is selected from 1 to 99. For example if
the number of slices is 4 pcs; the machine is slicing groups of 4 pcs with a distance from 1
to 99. The forward feed stops after 4 slices for moving the product on the conveyor as
selected from 1 to 99 and then continues slicing.
Run on time
Time in seconds after the cutting procedure is finished the conveyor is running.
Example:
A product should be slice in groups of 5 pcs. and be put on the outfeed belt.
The groups should place with a certain distance to each other on the belt..
Adjustment parameters:
Enter slice thickness:
e.g. 10 mm
Enter no. of slices:
5
Enter blade speed:
e.g. 80 %
Enter belt speed:
e.g. 25
Enter distance of the portioned products:
e.g. 60
COMMENT!
The distance between the single product groups to be cut shouldn`t
be bigger than speed of the conveyor belt (each in figures) in order
to have a sufficient distinction between each group.