Meyer EZ-Mount Plus, Operation And Maintenance Manual

Page: 9 / 36

Crankstand Storage To store Crankstand on the Lift Frame slide the tube that is attached to the side of the Crankstand over the receiver
tube on the driver’s side of the Lift Frame. Insert the chain locking pin through the vertical holes on both the tubes. Note: Crankstand
should always be fully retracted (up) and be pinned in the vertical transport position when not in use. Receiver Tube Cap may be
placed over the driver side transport tube while the Crankstand is in use on the A-Frame. The Receiver Tube Cap may also be switched
over to the Adjustment Tube of the A-Frame when the Crankstand is mounted to the Lift Frame.
Storage of the Crankstand is the
responsibility of the operator. The stand can be stored on the lift frame in the retracted position to the driver’s side transport
tube or inside the vehicle cab.
1
Lower Plow to float position and manually push lift arm
down. Disconnect the electrical connection.
2 Remove crankstand from storage position on the
side of mount and reattach to “A” frame. Crank until
front of truck rises slightly.
3
Pull, then rotate blue pins on both sides of truck
into locked out position. The vehicle is now free
from mount and may safely back away.
1 Drive into assembly until contact is made and push
assembly a few inches forward.
REMOVAL
ATTACHMENT
2 Rotate blue pins until engaged and push top of lift
frame towards truck until pins click in place.
3
Return crankstand to storage position and
reattach the electrical connection. The mount
is now securely attached to the vehicle and
is operational.Always confirm pins are fully
engaged before over the road or snow plow
operation.
-7-
Storage position