Meyer EZ-Mount Plus, Operation And Maintenance Manual

Page: 7 / 36

HAND HELD CONTROLLER
The snow plow should only be in operation when the vehicle ignition
switch and the control switch are in the ìONî position. Care should be
taken to insure that the control switch is kept dry and free from moisture
during normal operation.
When the control switch is turned ìOn,î lights illuminate the location of
the individual touch pads for the functions of the snow plow: Up, Angle
Left, Angle Right, Left Extend (V only), Left Retract (V only, Right Extend
(V only), Right Retract (V only), Scoop (V only), Vee (V only) and Down.
This switch has an auto detect feature which allows it to operate either
the E-58H or V-68 unit.
Lowering of the snow plow an inch at a time is possible by tapping the
down arrow in short intervals. Holding down the down arrow will activate
a float light located in the upper right corner of the control switch. This
light indicates the snow plow is now in the Lower/Float position. In this
position the snow plow will be able to follow the contour of the road and
the snow plow can also be angled to the left or right. Touching the up
arrow automatically cancels the Lower/Float position.
While angling left or right or raising the snow plow if the button is pressed
for more than six seconds the operation will be cancelled. This feature
eliminates unnecessary amp draw from the vehicle charging system.
The auto lower button (ALM) when pressed will blink the back light in
a (1) blink pattern and allows the plow to lower automatically when the
vehicle is shifted into reverse and raise automatically when shifted out
of reverse. To turn off the auto lower mode simply press the auto lower
button twice again until the back light is not flashing.
The auto raise button (ARM) when pressed twice will blink the back light
in a (2) blink pattern and allows the plow to raise automatically when the
vehicle is shifted into reverse and lower automatically when shifted out
of reverse. To turn off the auto raise mode simply press the auto raise
button again until the back light is not flashing.
This switch is self diagnosing. The monitor light is located in the upper
left corner next to the float light of the control switch. When the monitor
light turns on and begins to flash the control switch is sensing a problem
with a specific coil/connection on the hydraulic unit. The label below is
on the back side of your control switch.
Reset is accomplished by turning off the ignition switch or by turning
the power switch off momentarily and then back on. If the monitor light
is still illuminated after attempts to reset the switch have failed, contact
your nearest authorized Meyer Distributor for repairs.
When the controller is turned on it will activate the snow plow lights.
When the controller is turned off or removed from the harness this will
activate the vehicle headlights.
-5-
Snowplow Controller Operation
BACK/REAR
TOP/FRONT
FLOAT
MODE
ON/OFF
RIGHT WING
CONTROL
AUTO V MODE
UP/DOWN
LEFT/RIGHT
SCOOP
MODE
LEFT WING
CONTROL
SYSTEMS
MONITOR