Metrologic MS7320 InVista Series, Installation And User Manual

Page: 21 / 60

17
A
UDIBLE
I
NDICATORS
When the MS 7320 scanner is in operation, it provides audible feedback. These
sounds indicate the status of the scanner. Eight settings are available for the
tone of the beep (normal, 6 alternate tones and no tone). To change the tone,
use the
Multi-Function Button or refer to the MetroSelect
®
Programming Guide.
One Beep
When the scanner first receives power, the green LED will turn on,
the red LED will flash and the scanner will beep once. (The red
LED will remain on for the duration of the beep.) The scanner is
now ready to scan.
When the scanner successfully reads a bar code, the red LED will
flash and the scanner beeps once (if programmed to do so). If the
scanner does not beep once and the red light does not flash, then
the bar code has
not been successfully read.
Razzberry Tone
This is a failure indicator. Refer to failure modes page 19.
Three Beeps - during operation
When placing the scanner in program mode, the red LED will flash
while the scanner simultaneously beeps three times. The red and
green LEDs will continue to flash until the unit exits program mode.
Upon exiting program mode, the scanner will beep three times and
the red LED will stop flashing.
When configured, 3 beeps can also indicate a communications
timeout during normal scanning mode.
When using one-code-programming, the scanner will beep three
times (the current selected tone), followed by a short pause, a high
tone and a low tone. This tells the user that the single
configuration bar code has
successfully configured the scanner.
Three beeps will also occur during a manual adjustment of the
beeper tone. With each short depression of the
Multi-Function
Button , the new tone will be heard, followed by a short pause then
two more of the new current tones.
Three Beeps - on power up
This is a failure indicator. Refer to failure modes page 19.