Autolab/Electronic load combination
30 |
P a g e
Figure 24 – The updated procedure editor
The parameter provided by the
Control external device command can be linked to
other commands, like an
Input box command or a Repeat for each value
command, as show in Figure 25.
Figure 25 – Linking the electronic load setpoint to an
Input box
command
12
– Recording the output from the electronic load (DC only)
The output of the electronic load is fed back to one of the external inputs of the
Autolab. If the conversion settings are specified properly, as indicated in Section 9,
the output from the load can be converted directly and recorded by the NOVA
software.
To sample the output of the electronic load, the corresponding signal can be
added to the Signal sampler, as shown in Figure 26.
