Autolab/Electronic load combination
27 |
P a g e
11
– Procedure control of the electronic load (DC only)
The discharge current of the electronic load can be adjusted in a NOVA procedure
as well using the
Control external device command. This is possible provided that
the settings are specified correctly (see Section 9).
To define the discharge current setpoint of the electronic load at any time in a
NOVA procedure, the
Control external device command can be used. To edit the
settings, click the button next to this command in the procedure editor (see
Figure 20).
Figure 20 – Using the Autolab control command to edit the current setpoint of the electronic
load
A new window, called Autolab control, will be displayed (see Figure 21).
Note
Remember to switch on the load switch in order to allow the current to be
drawn from the cell.
