Metrodata ATM CBR DSU, User Manual

Page: 35 / 128

CONFIGURING THE ATM CBR DSU
25 76-02-031E
5 CONFIGURING THE ATM CBR DSU
When you have completed the installation, and have successfully logged on, you will be
presented with the
MAIN SET-UP menu. In order to view or change a parameter, you need
to know which menus or options to display. This section describes how to navigate your way
through the menus. In Figure 5.1 below, the shaded boxes represent screens that lead to
further menus. The menu structure chart at the rear of the manual gives more detail. The
example used in the Figure is the CBR5900 with an E3 CBR port and an SDH/Sonet WAN
port.
Figure 5.1 ATM CBR DSU menu structure version 3.x
General set-up
Main set-up menu
Time, Date, Nodename, Password,
,
Telnet Timeout
Framing, Line coding, Timing,
AIS Detection
Framing, Line coding, Timing, AIS Forwarding,
RAI Forwarding, Physical interface, Type of cable,
Distance option
VPI, VCI
V.24 set-up
Special
Testing
Management
Terminal type, Baud rate, Parity, Data bits
Stop bits, Modem support, Load new config
UNI Local loop, UNI Outside loop
CBR Local loop
Software version, Hardware version,
Buffer reset, Warm start, Cold start,
system Event log, alarM event log, cOnfig event log
LM1100 option must be fitted
Interface, Display mode, Summary style
Physical layer stats, Error type,
Performance data
ATM stats/AAL1 stats, Clear all data
(PLCP layer stats),
Special
ATM masks Idle cell masks GFC, VPI, VCI, PT, CLP
Good cell masks
GFC, VPI, VCI, PT, CLP
Clear alarm outputs
CBR port alarm set-up menu
UNI port alarm set-up menu
Alarm eXtension
WAN port set-up
E3 CBR
LINE port
SDH/Sonet
ATM UNI port
ATM port set-up
SDH/Sonet
ATM UNI port
E3 CBR
LINE port
Forward idle cells, HEC coset,
Payload scrambling, Idle cell payload