REV. 11/11/2020 INST99-7397B
7
7
ASWC PROGRAMMING
(SOLD SEPARATELY)
CONNECTIONS
(CONT.)
3.5mm jack steering wheel control retention:
•
For the radios listed below:
Connect the included
female 3.5mm connector with stripped
leads
, to the male 3.5mm SWC jack from the wiring harness included with the kit. Any
remaining wires tape off and disregard:
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/
White
wire of the connector. Then connect the remaining steering wheel control
wire, normally
Brown/White
, to the
Brown
wire of the connector
.
•
Metra OE:
Connect the steering wheel control Key 1 wire
(Gray)
to the
Brown
wire.
•
Kenwood or select JVC with a steering wheel control wire:
Connect the
Blue/
Yellow
wire to the
Brown
wire.
Note:
If your
Kenwood
radio auto detects as a
JVC
, manually set the radio type to
Kenwood
. See the instructions under changing radio type.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
•
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack into the AX-SWC-PARROT
(sold separately), and then connect the 4-pin connector from the AX-SWC-PARROT
into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to
as Key-A or SWC-1, to the
Brown
wire of the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the
Brown/White
wire
of the connector. If the radio comes with a third wire for ground, disregard this wire
.
Note:
After the interface has been programmed to the vehicle, refer to the
manual provided with the radio for assigning the SWC buttons. Contact the radio
manufacturer for more information.
• For all other radios:
Connect the 3.5mm jack from the wiring harness included with
the kit into the jack from the aftermarket radio designated for an external steering
wheel control interface. Please refer to the aftermarket radios manual if in doubt as to
where the 3.5mm jack connects to.
Continue to Installation
