17.12.2004
Rev. 2.0
Operation instructions
7
H Stop the mixer by pressing the red stop button 0.
4.1.1
Recommended maximum speeds
Please take note of the recommended maximum speeds below:
4.1.2
Procedure for starting after emergency stop
This procedure must be used in cases where the mixer has been stopped in high speed.
•
Lower the bowl and remove the tool from the bayonet.
•
Raise the bowl arms,either empty or with the bowl.
•
Close the safety guard, start the mixer and move the speed selector lever back to
the lowest speed.
•
Switch off the mixer. Now the mixer can be started as usual.
4.1.3
Overload
Do not overload the mixer. Sticky and heavy doughs may reduce the capacity of the bowl
by 75%. The capacity is further reduced if the speed of the mixing tool is increased be-
yond the recommended values or if a wrong mixing tool is used. Large lamps of fat or
cooled ingredients must be cut into small parts before they are placed in the bowl.
Prolong overload will make the mixer’s motor protection disconnect the mixer. Leave the
mixer for approx. 3 minutes and restart it again as described under “Procedure for starting
after emergency stop”.
Summary of Contents for AR 30 MK 1
