Operating Instructions
Initial Operation
METACAP Spray Gun D/A
7-14
Version/Edition July 2008
7
Initial Operation
Note:
The position numbers refer to the figure 1, see chapter 6.2 Structure of the
METACAP Spray Gun D/A, page 6-11.
Important note:
To ensure that no residual matters have a negative effect on the spray
results, use an appropriate solvent to thoroughly rinse the METACAP Spray
Gun D/A before initial operation.
Attention!
Before using the METACAP Spray Gun D/A for the first time, carefully and
thoroughly read the complete content of this operating manual to avoid
possible dangers and damages caused by an incorrect use of your spray
gun.
The same applies to new staff members who have to work for the first time
with a METACAP Spray Gun D/A that has already been in use.
Since the handling and operation of the METACAP Spray Gun D/A are
different compared to other spray gun types, it is recommended to practice
the manipulation and adjustment of this spray gun using water before using
any coating materials.
The same applies to new staff members who have to work for the first time
with a METACAP Spray Gun D/A that has already been in use.
—
Ensure the air supply by mounting the quick connect coupling NW 7,2 of
your compressed air tube on the plug-in nipple (1/52) of your spray gun
until it locks and latches audibly and perceptibly. If you are not sure, pull
the air hose to check the firm connection.
—
Establish the coating material supply by connecting your material tube
with a union nut (3/8") and the threaded connection piece for paint
(1/29), then use an appropriate wrench to tighten the nut.
If you are using bottom cup sets, please install these cups according to the
corresponding mounting instructions belonging to the scope of supply of
your cup set.
