Operating Instructions
Description of the METACAP Spray Gun D/A
METACAP Spray Gun D/A
2-4
Version/Edition July 2008
2
Description of the METACAP Spray Gun D/A
The METACAP Spray Gun D/A was developed for the combined use with
conveying equipment and circulation systems for coating materials and with
METACAP bottom cup sets.
2.1
Technical Data
Hose couplings
Air supply 1/4" outside thread with plug-in nipple
for quick connect coupling NW7, 2 equipped.
Material supply 3/8" outside thread
Maximum
working
pressure
Air supply PI 10bar max.
Material pressure 8bar max.
Weight
680g without cup,
Bottom cup set 0.5L - 305g
Bottom cup set 1.0L - 370g
Accessories
Bottom cup sets for 0.5 and 1.0 L
item no. 101115A and 101115B
Recommended
air
pressure
3 – 6 bar for at least 300 L/min of efficient air
supply
The compressed air must be dry and oil-free.
Minimum inner section of the feed pipe: 9mm
Material pressure
The material pressure depends on the coating
material and can be adjusted on the paint delivery
unit (maximum: 8 bar).
When using bottom cup sets, the material
pressure results from the spraying pressure.
2.2
Identification
Note:
The identification was effected according to DIN EN 1953 "Atomising and
Spraying Equipment for Coating Materials– Safety Requirements", section
7.2 "Identification".
The serial number of the spray gun is recorded on the left side of the spray
gun handle, the maximum air pressure and the maximum pressure for the
coating material are indicated on the right side of the spray gun handle.
