Merrylock MK 4055, Instruction Book

Page: 17 / 33

10cm
(4")
* While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
16
3
3
* Turn the hand wheel toward you until the cover
stitch looper extends out 10mm from the stitch
plate edge.
* Thread the looper area of the machine following
the brown color-coded thread guides 4~12.
Note : Use the tweezers provided in the accessory
case to aid in threading the looper.
* Place the thread with the point of the tweezers
through threading guide 4~7.
* Thread the Chainstitch
thread guide (8) by holding
the thread in front of the
thread guide pin and pulling
the thread backward and
up, until the thread rests
inside the thread guide loop
and under the spring.
* Position thread through in guide 9. Pull thread in
front the board and through guide 10.
* Thread the looper eye 12 from front to back. Pull
about 10cm (4 inches) of thread through the
looper.
* Press down the threader guide board (A) and pull
to the right side out.
* Release the threader guide board (A) that
automatically spring back and pull thread into
guide 11 and make sure the threader guide board
(A) to the leftmost point.
4
4
5
6
7
8
9
10
12 11
8
10
12
9
11
A
A
12