Merrylock MK 4055, Instruction Book

Page: 21 / 33

20
* Pass thread from back to the front through the
thread guide 1.
* Thread the top cover thread guide by pulling the
thread towards the right until it slips under guide.
Then pull thread along the right side of button as
illustrated.
1
2
2
3
3
4
5
6
7
8
9
10
5
* Continue to thread points 4~9.
* Slip the thread into the front slot on the thread
guide (5) and into the slot on the take-up lever
cover (6). Then slip the thread into the left slot on
the thread guides (7) and (8).
* Before threading the eye of the needle, make sure
thread is in front of thread guide located on the
bottom of the needle clamp (9).
* Thread the eye of the left needle. Use the needle
threader (page 21) to make the threading easier.
* Pull about 10 cm (4") of thread through needle
eye to hang free.
* Place the thread to the back, under the presser
foot.
* While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.