11
7. PREPARATION FOR THREADING
(1) SETTING UP THE THREAD GUIDE
HOLDER
* This machine is shipped with the thread guide
holder on the top of Styrofoam.
* Fully extend the thread guide holder.
* The two joints on the telescope will click into place
when they are correctly positioned.
* Center the thread guides above the spool pins.
* Place thread over the cone adapters on the spool
pins.
Note : Your new machine is threaded to sew Triple
Cover Stitch. Refer to Page 15 for
instructions on tying on to the threads.
Anti-spill net
(2) ANTI-SPILL NET
*
When using synthetic threads that easily spill off
the cone, slip the anti-spill net furnished with the
machine over the thread from the bottom of the
cone leaving the thread end hanging free at the
top the anti-spill net as shown at right.
6. TELESCOPIC THREAD STAND
* Place the thread spools over the cone holders on
the spool pin.
* If the machine is already threaded, straighten the
threads to prevent tangling.
1
2
Summary of Contents for MK 4055
Page 1: ...INSTRUCTION BOOK INSTRUCTION BOOK INSTRUCTION BOOK...
Page 33: ...J1P17...