G815
D
May 05
12
Board setup
It is strongly recommended to follow the procedures in the order below:
1.
Make all Connections
2.
Set the application mode
3.
Learn a remote control
4.
Set motor limit cams
5.
Run Easy Setup
6.
Adjust Controls
7.
Run Professional or Easy Setup again
8.
Learn wireless remote controls
Make all connections
NOTE
When powering any accessories from the board, (for example: gate latches,
additional receivers, keypads, PE beams) ensure the total combined load on the VA and
TXF terminals does not exceed 150 mA. If necessary, remove accessories or provide
additional power supplies directly to each accessory.
transformer in
transformer in
battery in - ve
battery in + ve
motor 1 out (first to open)
motor 1 out
motor 2 out (first to close)
motor 2 out
flashing light out + ve
flashing light out - ve
lamp / lock module – ve (black)
lamp / lock signal out (grey)
lamp / lock ve (red)
photocell power out
accessory power out
ground
photocell signal in (NC)
start signal in (NO)
ground
stop signal in (NC)
pedestrian access in (NO)
ground
antenna in