35
2.
Install the drive pinion bearing cage.
Figure 5.32
.
3.
Install the washers and fasteners and tighten
them to the torque value specified in
Section 7.
Figure 5.33
.
4.
Hold the yoke with an adequate tool and
tighten the pinion nut to the minimum torque
value specified in Section 7.
Figure 5.34
.
5.
Using a torque wrench, tighten the pinion nut
(to the maximum limit allowed) according to
the table of values specified in Determine
Bearing Preload in this section.
Assemble the Main Differential and
Ring Gear Assembly
1.
Apply Shell 71032 Alvania EP-2 or
Texaco 995 Multifak EP-2 grease in the
holes of the side gears. Install the bearings
and the spacers on their respective gears.
Figure 5.35
.
2.
Check the gear holes for burrs and make sure
that the original position of the components
has not changed.
3.
Position the side gears and the inner and outer
thrust washers in the side gear case gradually.
Align the washer holes with the holes in the
case for easier insertion of the shafts.
Figure 5.36
.
4.
Install the side gear shafts.
Figure 5.32
Figure 5.33
Figure 5.34
Figure 5.35
Figure 5.36