32
6.
Install the drive pinion front bearing lock
washer and the splined nut, tightening
manually.
Figure 5.22
.
7.
Check if the drive pinion and the carrier
surface contacts are clean and free of
scratches or scores.
8.
Install the drive pinion, without shims, in the
carrier and regulate its height.
Figure 5.23
.
9.
Install four capscrews and initially tighten in a
cross sequence.
Figure 5.24
.
10. Then with a torque wrench in the same cross
sequence, apply the following torque values:
67-91 lb-ft (90-125 N•m).
Figure 5.25
.
11. Check if the differential case assembly bearing
housing and the special tool centering disks
are perfectly clean and lubricate them with a
film of oil.
12. According to the model of the differential,
install the appropriate centering discs, with
their respective shafts in the bearing housing
of the differential case.
13. According to the model of the rear axle, select
the appropriate shim pack. Refer to the chart
below.
Model
Shim Pack
220/224
4.72 mm
230
11.10 mm
240
23.80 mm
Figure 5.22
T
Figure 5.23
Figure 5.24
Figure 5.25