COPYRIGHT © 1996 MERIT INDUSTRIES, INC.
4
SCORPION™ 9000 MANUAL
PM0015-0B
(c) Mount the right bracket (MW4029) to
the hood using (2) carriage bolts and
wing nuts.
11.
Using (4) #10-24 wing nuts (HW3253),
mount the overhead display to the brackets
installed in step 10.
12.
Route the overhead display wire up through
the hole in the wood filler and down through
the slot on the left, top of the machine.
Connect the wire to the 3-pin female
connector on the power supply.
13.
Route the ribbon cable from J7 on the
STG01 board up through the overhead
display and over the top of the game.
Connect the other end to the connector on
the top, left side of the game.
14.
On games equipped with the linear power
supply, attach the line cord to the AC power
supply at the base of the cabinet. Tighten the
cable lock assembly so that the cord is
secured to the game.
15.
Attach the price decal above the control
panel, as shown in Figure 13.
16.
Proceed to Section 3 - Testing Your Game.
Disconnecting the Cancel Game Feature
If the Cancel Game feature is not needed, you may
disable the option by following the steps given below.
1.
Open the target section door.
2.
Locate the cancel game switch assembly on
the left side of the cabinet.
3.
Disconnect one or both of the wires attached
to the Cancel Game switch. This will disable
the cancel game feature.
4.
Close the target section door.
