nadac.merging.com
Page 62
To launch the NADAC App from Apple iOS for iPad and iPhone
1.
Connect the NADAC to a computer in an advanced network configuration basic network
configuration as shown on page 44, steps 1 to 7.
2.
Launch the NADAC App on your iPad or iPhone. The remote control window will open and the Ap will
search for any NADAC devices on the network. While it is searching a spinning gear wheel will be
displayed. If the spinning wheel is not replaced by another window after about 15 seconds, there is a
problem in how the system has been set up. Check that the Ethernet cables are correctly connected
(correct socket and plug fully home); that the wireless router is switched on and the wireless section is
enabled and that your iPad or iPhone is locked to the wireless signal from this router. If all else fails, close
down file server software and the NADAC and then restart each in turn.
3.
In most cases the next window displayed will be the App Home page, Figure 80. In this case go to step 4.
Sometimes you will see the App’s Devices page, Figure 79. For each unit discovered on the network a
NADAC icon showing the unit’s serial number will be displayed as shown. An icon for the music server
may also be displayed if the software is running. You should start this software now. In the example we
are using Merging Technologies’ Emotion music server software.
4.
To select the NADAC you wish to control, tap on its icon. The App will then connect to this unit and
display its Home page, which shows the unit’s key settings - Figure 80. Tapping on the music server
software icon, Emotion in this case, will cause this software to open in a browser window.
Figure 79. NADAC App Devices page.
Summary of Contents for MERGING+NADAC
Page 1: ...REFERENCE GUIDE ...
Page 75: ...nadac merging com Page 74 ...
