2A -10 REMOVAL AND INSTALLATION
90-816462 2-695
5. Connect throttle cable using hardware retained
and adjust as follows:
a. Place remote control handle(s) in neutral, idle
position.
IMPORTANT: Be sure that cable is routed in such
a way as to avoid sharp bends and/or contact with
moving parts. DO NOT fasten any items to throttle
cable. Outer cable must be free to move when
cable is actuated.
50634
c
a
b
a - Anchor Bolt
b - Use This Boss - 3.0L
c - Use This Boss - 3.0LX
b. Install cable end guide on throttle lever, then
push cable barrel lightly toward throttle lever
end. (This will place a slight preload on cable
to avoid slack in cable when moving remote
control lever.) Adjust barrel on throttle cable to
align with anchor stud.
c. Secure throttle cable with hardware (re-
tained) as shown. Tighten cable end guide
locknut until it bottoms out and then back off
one full turn. Tighten cable barrel securely.
DO NOT OVER-TIGHTEN, as cable must piv-
ot freely.
50626
d
e
a
b
c
a - Cable End Guide
b - Throttle Cable Anchor Screw
c - Cable Barrel
d - Elastic Stop Nut and Flat Washer
e - Throttle Lever
d. Place remote control throttle lever in the
wide-open-throttle (W.O.T.) position. Check
to ensure that throttle shutters (valves) are
completely open and throttle shaft lever con-
tacts carburetor body casting.
Summary of Contents for 13
