![Mercia Garden Products 0628RANE0504FGDD2TW1SW-V1 Instructions Manual Download Page 7](http://html1.mh-extra.com/html/mercia-garden-products/0628rane0504fgdd2tw1sw-v1/0628rane0504fgdd2tw1sw-v1_instructions-manual_1772578007.webp)
P 7
IMPORTANT:
Pre-drill before fixing screws.
22a
Pre drill
hole
30mm
screw
15
14
22
Step 10
Parts Needed - No. 14 QTY 1
No. 15 QTY 1
No. 22 QTY 6
The Adjustable Door Hinge
(No.22)
comes in three parts.
Fasten No. 22a into 22b as shown in the
illustration.
Once the framing is enclosed,
place
the secondary and master doors
(No. 14 & 15)
into the assembled frame
Fix the Adjustable door hinge
(No.22c)
to
the doors using 3x30mm screws per hinge.
Fix 3 x Adjustable Door Hinges
(No.
22a&b)
into position onto the door frame
using 4x30mm screws per hinge.
*Ensure the hinges are fitted to the exter-
nal of the door frame so the doors open
outwards from the log cabin.
Locate the doors into the hinges ensuring
there is equal spacing on each side
between the doors and door frame, and
that the doors open and close freely with-
out restriction.
It is important to fit the doors within the
frames at this stage so that you can estab-
lish the position of the hinges. The hinges
come in three parts. Remove the doors
from the framing after fitting.
*Ensure to screw into the framing
and not into the channel.
42x30mm Screws
a
b
22b
a
b
Secondary Door
Master Door
22
Step 11
To adjust and align your doors:
1. Lift up the doors to seperate the two
parts of the hinge.
2. Turn the rotating barrel
(No.22a)
in /
out to move the postion of the doors
either in or away from each other.
3. You can then place the door(s) back
on to the hinge and check whether they
require more / less adjustments, if
further adjustments are required repeat
number 2.
22a
Please retain product label and instructions for future reference
Step 12
Once you have laid 6 log boards (
on top of the
starter board
) up the door section, slide the
assembled door frame
(without main doors)
over the boards resting the frame on top of the
starter board.
Please refer to steps 9 to construct your door
frame assembly.
*Please note:
This image is for illustrative purposes
and may differ from your choice in product
(
regarding door position
). Nevertheless the
process of fitting the door frame is the same.