P 11
Please retain product label and instructions for future reference
IMPORTANT:
Pre-drill before fixing screws.
Step 21
Parts needed - No. 36 QTY 92
Place the first two roof board’s
(
No. 36
) onto the log cabin on
each side, making sure the boards
are flush to the end of the roof
purlin. Once in position fix to each
purlin using 4x40mm screws.
*Ensure the roof boards meet
at the top of the apex and leave
an overhang at the bottom.
Ensure the roof boards are not laid too
close together, use the spacers (
No. 47
)
provided to create a 2mm gap. Adjusting
the spacing between the boards allows
the wood to swell in damp weather.
*Please note that you have been
issued with 92 roof boards.
However, in reality you may only
need to use 90.
Continue adding the roof boards
along the roof, fixing each one into
position using 4x40mm screws,
making sure that each board is
interlocked, flush at the bottom &
meet at the top of the apex.
The last board on each
side will overhang: Using a
straight edge and a pencil mark
out a line as a guide.
Cut along the pencil mark and
remove the excess. Place the
cut down board’s back onto the
roof and secure into place
using 4x40mm screws per
board.
*Please Note:
This image is for illustrative
purposes and may differ from your choice in
product. Nevertheless the process of cutting
and fitting the last roof boards is the same.
368x40mm Screws
40mm
screw
Pre drill
hole
*
Cut to fit
a
b
7
b
23b
36
36
a
Step 22
Parts needed - No. 43 QTY 4
Ensuring the roof boards are
flush at the overhanging side
and meet at the apex, fix the
Eaves Frames (
No. 43
) to the
underside of the roof boards
using 9x40mm screws as shown
in the illustration.
*Please Note:
This image is for
illustrative purposes and may
differ from your choice in
product. Nevertheless the process
of fixing the eaves frames is the
same.
36x40mm Screws
40mm
screw
Pre drill
hole
IMPORTANT:
Pre-drill before fixing screws.
28
43
