![Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual Download Page 124](http://html1.mh-extra.com/html/mercedes-benz/sprinter-907-2018/sprinter-907-2018_operating-instructions-manual_1771924124.webp)
#
If possible, drive at an engine speed of at
least 2000 rpm during regeneration.
The diesel particulate filter's burn-off process
is assisted by the intentional temperature
increase.
#
To cancel regeneration: switch off the
engine.
Regeneration is cancelled. If regeneration is
not completed, you can restart regeneration
after starting the engine again.
Depending on the load condition of the diesel
particulate filter, regeneration starts automat‐
ically when you drive the vehicle again.
Battery main switch
Notes on the battery main switch
*
NOTE Damage to the electrical system
If you remove or disconnect the battery main
switch, it could lead to the electrical system
becoming damaged.
#
Make sure that the ignition is switched
off and that at least 15 minutes have
passed before removing or reconnecting
the battery main switch. Otherwise,
electrical system components could be
damaged.
You can use the battery main switch to discon‐
nect the current to all your vehicle's consumers.
This will prevent uncontrolled battery discharge
caused by quiescent current consumers.
If your vehicle is equipped with an auxiliary bat‐
tery in the engine compartment or in the base of
the co-driver's seat, you must disconnect both
batteries. Only then is the electrical system fully
disconnected from the power supply.
%
Only disconnect from the power supply using
the battery main switch if:
R
the vehicle is stationary for a long period
of time
R
it is absolutely necessary
After switching on the power supply, you will
need to reset the side windows (
and the electric sliding door (
%
A break in the power supply is entered in the
DTCO (digital tachograph) as an event in the
fault memory.
See the separate DTCO operating instruc‐
tions.
Switching the power supply on/off
Switching off the power supply
#
Switch off the ignition and wait at least 15
minutes.
#
Remove cover
1
.
#
Press and hold button
3
.
#
Pull plug
2
out of the earth pin.
#
Push plug
2
as far as possible in the direc‐
tion of the arrow so that it cannot make con‐
tact with the earth pin.
All starter battery consumers are disconnec‐
ted from the power supply.
Switching on the power supply
#
Press plug
2
onto the earth pin until you feel
it engage and plug
2
is in full contact with
the earth pin.
All starter battery consumers are reconnec‐
ted to the power supply.
#
Fasten cover
1
.
Manual transmission
Using the gearshift lever
*
NOTE Damage to the engine and trans‐
mission by shifting to a gear that is too
low
#
When changing between gears
5
and
6
push the gearshift lever to the right.
#
Do not shift down at high speeds.
122
Driving and parking