Mercedes-Benz 2010 E 350 4MATIC, Operator'S Manual

Page: 345 / 372

i While being towed with the hazard
warning flasher in use, use the combination
switch in the usual manner to signal turns.
Only the selected turn signal will operate.
Upon canceling the turn signal, the hazard
warning flasher will operate again.
Fuses
Introduction
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and
systems secured by that fuse will stop
operating.
G
Warning!
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system in
question and do not attempt to repair or
bridge a blown fuse. Using other than
approved fuses or using repaired or bridged
fuses may cause an overload leading to a fire,
and/or cause damage to electrical
components and/or systems. Have the cause
determined and remedied by an authorized
Mercedes-Benz Center.
A blown fuse must be replaced by an
appropriate spare fuse (recognizable by its
color or the fuse rating given on the fuse) of
the amperage recommended in the fuse
chart. Any Mercedes-Benz Center will be glad
to advise you on this subject.
i In case of a blown fuse contact Roadside
Assistance or an authorized Mercedes-
Benz Center.
If a newly inserted fuse blows again, have the
cause determined and rectified by an
authorized Mercedes-Benz Center.
The fuse chart is located in the trunk with the
vehicle tool kit (
Y
page 268). The fuse chart
explains the fuse allocation and fuse
amperages.
Before replacing fuses
X
Engage the parking brake.
X
Make sure the automatic transmission is in
park position
P.
The transmission position indicator in the
multifunction display should be on
P .
X
Switch off all electrical consumers.
X
Turn off the engine.
X
Remove the SmartKey from the starter
switch.
X
Vehicles with KEYLESS-GO: Open the
driver’s door (this puts the starter switch in
position
0, same as with the SmartKey
removed from the starter switch). The
driver’s door then can be closed again.
Fuse box in trunk
X
Open the trunk.
X
Opening: Insert flat, blunt object as a lever
into the upper edge of cover
:
and pull
cover
:
downward in direction of arrow.
X
Closing: Install cover
:
.
Fuse box in engine compartment
X
Open the hood.
Fuses
343
Practical hints
212_AKB; 2; 41, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-17T09:14:21+02:00 - Seite 343
Z