Mercedes-Benz 2010 E 350 4MATIC, Operator'S Manual

Page: 219 / 372

X
Press button
=
approximately 3 seconds.
The currently selected zone appears in
compass display
;
.
X
Selecting zone: Press button
=
until the
desired zone is selected.
Do not press the button again until the
direction is indicated.
X
Compass calibration: Make sure you are
in an area where you can drive a full circle
with your vehicle without disturbing traffic
in order to calibrate the compass.
In order to calibrate the compass properly,
mind the following:
R
Calibrate the compass in open terrain.
Nearby buildings, bridges, power lines and
large antenna masts, for example, could
impair compass calibration.
R
Switch off electrical consumers (e.g.
climate control, windshield wipers, or rear
window defroster).
R
Close all doors and the trunk.
X
Start the engine.
X
Press button
=
approximately 6 seconds
until symbol C appears in compass
display
;
.
X
Drive a full circle at a vehicle speed of
between 3 mph (5 km/h) and 6 mph
(10 km/h).
When calibration was successful, the
current direction appears in compass
display
;
.
Floormat (driver’s side only)
G
Warning!
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
X
Move the driver’s seat as far to the rear as
possible.
X
Removing: Pull floormat off of retainer
pins
;
.
X
Installing: Press floormat eyelets
:
onto
retainer pins
;
.
Useful features
217
Controls in detail
212_AKB; 2; 41, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-17T09:14:21+02:00 - Seite 217
Z