X
To switch on: set
Dynamic route
as the
route type
28
.
Proceed as described in the "Setting the
route type" section (
Y
page 140).
X
To switch off: select a different route type.
i
COMAND calculates a new route if you
change the route type setting with route
guidance active. If you change the route
type setting when route guidance is inac-
tive, COMAND uses the new setting for the
next route guidance.
If TMCpro is received, this is indicated by the
TMCpro
symbol at the lower right in the dis-
play.
If a public TMC service is received, the
TMC
symbol appears at the lower right in the dis-
play.
If RDS-TMC reception is not possible, no sym-
bol will appear.
RDS-TMC displays on the map
COMAND can show certain traffic incidents
on the map. These displays can be seen on
map scales 50 m (0.05 miles) to 50 km (50
miles).
X
To set the map scale: turn
c
V
d
until the
desired map scale is set.
Turning clockwise enlarges the map, turn-
ing anti-clockwise reduces the map.
Example display of a traffic jam on the route
:
Icon concerning an incident on the route:
in this example, a traffic jam
;
Section of route affected
=
Current position and direction of travel
?
Map scale selected
i
COMAND uses corresponding sym-
bols
;
to highlight the entire section of the
affected route. Symbols
;
are displayed
on the side of the carriageway affected by
the incident.
An overview of the possible symbol displays
is shown below.
:
Traffic jam on the route (symbol has red
outline)
;
Slow-moving traffic on the route (sym-
bol has red outline)
=
Road closure on the route
?
Traffic jam
A
Slow-moving traffic
28
Not available in all countries.
164
Navigation* route guidance with RDS-TMC
COM
AN
D
* optional
221_AKB; 2; 3, en-GB
bjanott,
Version: 2.11.7.7
2009-02-27T14:56:10+01:00 - Seite 164
Dateiname: 6515231002_buchblock.pdf; erzeugt am 03. Mar 2009 15:17:23; WK
