Moving the map and selecting the des-
tination
X
To move the map: slide
Z
V
Æ
,
X
V
Y
or turn
c
V
d
.
X
To set the map scale: turn
c
V
d
.
X
To select a destination: press
W
.
If the crosshair is located outside the digital
map, it is not possible to calculate a route
to this destination and you will see the mes-
sage
The destination is located
off the map
.
X
Select
OK
.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map. This takes
approximately two seconds.
If the destination can be assigned, you will
see the address of the destination. If not,
you will see the display
Destination
from map
.
X
To start route calculation: select
Start
(
Y
page 151).
Entering an intermediate stop
When route guidance is active, you can enter
an intermediate stop. Intermediate stops can
be predefined destinations from the following
predefined categories:
R
Mercedes-Benz Service
R
Hospital
R
Filling station
R
Car park
R
Restaurant
R
Other
You can select intermediate stops from the
route or the vicinity.
You can use the intermediate stop function to
influence route guidance to the main desti-
nation. When you have reached your inter-
mediate stop, COMAND automatically calcu-
lates the route to the main destination.
Entering predefined destinations
X
Select
Navi
Q
Destination
Q
Stop‐
over
.
If an intermediate stop has already been
entered, you can change this.
X
To change: select
Change stopover
.
You can now select a category.
X
To select a category: select a category,
e.g.
Filling station
.
COMAND first looks for destinations in the
immediate vicinity of the vehicle and near to
the vehicle’s route. If there are no destina-
tions available there, COMAND searches for
destinations in an area around the vehicle
position.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Select
OK
.
You can select a different category.
If COMAND finds destinations, you will see a
list of the destinations and details of how far
away they are in the right-hand side of the
display. It can take a few seconds for the
information about the distance to the desti-
nations to be displayed.
The left-hand part of the display shows the
destinations on the map. The destination
marked in the list is highlighted in the map.
X
To select a destination: select the desired
destination from the list.
The address of the destination appears.
X
To start route calculation: select
Start
,
see also (
Y
page 151).
Entering another destination as an
intermediate stop
X
Select
Navi
Q
Destination
Q
Stop‐
over
.
X
To enter: select
Other
.
154
Navigation system* (entering a destination)
COMAND
* optional
221_AKB; 2; 3, en-GB
bjanott,
Version: 2.11.7.7
2009-02-27T14:56:10+01:00 - Seite 154
Dateiname: 6515231002_buchblock.pdf; erzeugt am 03. Mar 2009 15:17:20; WK
