34
FV42
85-03-01068
10. Install the airbox and both rear and front burners in their original locations and positions and secure
down using screws you removed earlier.
11. Make certain front burner is running parallel to front face of unit positioned properly so that the pilot
hood pointing to the left is pointed properly toward the burner’s flame propagation ports.
12. Make certain rear burner is positioned properly so that the pilot hood pointing to the back is pointed
properly toward the burner’s flame propagation holes.
13. Next, the pressure regulator will be changed. To do this, first remove the left-side access panel mounted
to the left outer skin of the unit and lay down gently without disconnecting any wires of internal
components.
Warning: Do not force. Excessive force may damage internal wiring components.
14. See diagrams below and identify the pressure regulator on the valve body. Remove the left side controls
access panel. Gas valve and the pressure regulator mounted on the gas valve are accessible through the
opening on the left side.
15. Shut off the gas supply to the valve and shut down the electric supply.
Note:
Be careful when removing or tightening the screw on the back of the pressure regulator. The screw
location is difficult to access and care must be taken to ensure a proper seal when tightened.
f i r e - p a r t s . c o m
