7
2
FV42
85-03-01068
FIRST-TIME LIGHTING INSTRUCTIONS
Safety Information
•
This fireplace is equipped with an ignition device which automatically lights the pilot. Do not attempt to
light pilot by hand.
•
Before operating
, smell all around fireplace area for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
•
Toggle master switch to on. Fireplace burners will not ignite unless the master switch is on.
•
Use only the supplied remote control to light the pilot. This valve will not operate if the pilot is not lit and
stable.
•
Do not use this fireplace if any part has been underwater. Immediately call a qualified service technician to
inspect and replace any component which has been under water. Attempted operation may result in fire or
explosion resulting in property damage, personal injury, and loss of life.
Operating Instructions
1. Read the above safety information carefully before proceeding.
2. Do not attempt to light the pilot by hand; the door must remain on this unit during pilot ignition, except
for the “First Time Lighting”.
3. Press the On/Off button on remote control to begin the ignition sequence.
4. The fireplace will emit an audible beep then the igniter will begin to spark. After the pilot lights and is
established, the valve will automatically open and the burner will light. The burner will initially light to full
flame. Adjust it to an appealing setting with the remote. See Remote Operating Instructions in Operating
Instructions Manual.
Warning:
If the pilot fails to light, the system will “lockout”. Press On/Off button on remote control to turn
off the system. Allow five minutes for any gas in the unit to dissipate before attempting to re-light the
pilot.
5. Press On/Off button on remote control again to start ignition sequence.
6. If the fireplace will not operate, follow the instructions “To Turn off Gas to Fireplace” below and call your
service technician or gas supplier.
To Turn off Gas to Fireplace
1. Press the On/Off button on the remote control.
2. Turn off the external manual shutoff valve supplied by installer and mounted adjacent to fireplace.
3. Turn off all electric power to the fireplace if service is to be performed.
Warning: If you do not
follow these instructions
exactly, a fire or
explosion may result
causing property
damage, personal injury,
and loss of life.
WHAT TO DO IF YOU SMELL GAS
•
Do not light any appliance.
•
Do not touch any light switch
•
Do not use any phone in your building.
•
Call your gas supplier from a neighbor's phone.
•
Follow the provider representative's instructions.
•
If you cannot reach your gas supplier, call the fire
department for assistance.
f i r e - p a r t s . c o m
