6
6
FV42
85-03-01068
OPERATION INFORMATION
Using Your Remote Control
Your Mendota remote control is pre-programmed to your fireplace. Ensure you have installed 3 AAA
batteries into your remote.
Press the top button on the remote control. If you do not hear a beep when you press this button, follow the
instructions below to synchronize your fireplace and remote control.
Synchronizing the Fireplace and the Remote Control
Note:
The master switch and sync switch are located on the bottom left corner of the fireplace. Follow the
steps below to synchronize:
1.
Toggle the
master switch
to “on” (toggle up). The fireplace burners will not ignite unless the master
switch is on
.
2.
Locate
sync switch
(above master switch). Press the sync button and release. The fireplace will
beep 3
times
indicating that it is ready to synchronize with a remote control. (
Note:
If you do not hear any
beeps when you press the sync button, contact your Mendota dealer or installer for assistance.)
3.
Within 7 seconds, press the “on” button on the remote control. The fireplace
will
beep
to indicate that
the remote control’s command is accepted and sets to the particular code of that controller.
Your system is now synchronized.
MASTER SWITCH
UP - ON
DOWN - OFF
SYNC SWITCH
f i r e - p a r t s . c o m
