InfiniBand Switch Platform Hardware User Manual
Mellanox Technologies
68
Step 5.
Check the mgmt0 interface configuration before attempting a remote (for example,
SSH) connection to the switch. Specifically, verify the existence of an IP address.
4.2
Re-Running the Wizard
To rerun the wizard:
Step 1.
Enter the config mode.
Step 2.
Rerun the wizard.
4.3
Downloading FabricIT Software and Documents
To download FabricIT software and documentation, please visit the following webpage:
http://www.mellanox.com/content/
pages.php?pg=ib_fabricit_efm_management&menu_section=55.
switch # show interfaces mgmt0
Interface mgmt0 state
Admin up: yes
Link up: yes
IP address: 169.254.15.134
Netmask: 255.255.0.0
IPv6 enabled: yes
Autoconf enabled: yes
Autoconf route: yes
Autoconf privacy: no
IPv6 addresses: 1
IPv6 address: fe80::202:c9ff:fe11:a1b2/64
Speed: 1000Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface source: physical
MTU: 1500
HW address: 00:02:C9:11:A1:B2
Comment:
RX bytes: 11700449 TX bytes: 15139846
RX packets: 55753 TX packets: 28452
RX mcast packets: 0 TX discards: 0
RX discards: 0 TX errors: 0
RX errors: 0 TX overruns: 0
RX overruns: 0 TX carrier: 0
RX frame: 0 TX collisions: 0
TX queue len: 1000
switch > enable
switch # config terminal
switch (config) # configuration jump-start
You need to enter the License Entitlement number and the switch S/N to obtain the
software and documentation, and also to generate an EFM license that enables
extended FabricIT management and inspection features on your switch system.
