InfiniBand Switch Platform Hardware User Manual
Mellanox Technologies
42
Figure 30: Management Module Numbering
Figure 31: Spine Board Extraction
If you need to hot swap spine #1 or spine #2:
1. Check to see if the spine you need to remove is connected to the master management
module. See Figure 30.
2. Follow the steps in Section below.
Extracting Spine Boards Except #1 or #2
1. Run the shut down command
“no power enable <module>”.
For example to shut
down spine 06 run the command below.
2. Push outward on the ejector handles to unlock the ejectors from the chassis.
Removing spine #1 causes management module #1 to reset.
Removing spine #2 causes management module #2 to reset.
Warning
: If the spine you want to hot swap is connected to the
master
management
module the management module will
reboot
when you take out the spine.
If you have only one management module the chassis will crash!
If you have only one management module, the chassis will crash!
switch [master] (config) # no power enable S06
MNG1 management module #1
(top)
MNG2 management module #2
(bottom)
1
3 5
9 11
2
4 6
8 10 12 14 16 18
17
15
13
7
35
33
31
27
25
36
34
32
30
28
26
24
22
20
19 21 23
29
Status
Fan Status
Pull the latches to remove the spine.
