- 10 -
2CD-7713v1/GDB5F40
Instructions Manual
【
】
Driver block
J6, J8
These are connectors to c24 V power supply for drivers.
The power shutdown can turn the power supply on and off independently of the power supply
in the controller's part.
J6 is the one for the X-axis, and J8 is the one for the Y-axis.
J7, J9
These are connectors to connect a motor.
J7 is the one for the X-axis, and J9 is the one for the Y-axis.
S3, S7
These are switches that sets for the motor driver each.
(
)
Please refer to the setting at chapter 3. for the details.
S3 is the one for the X-axis, and S7 is the one for the Y-axis.
S4, S8
These are DRIVE I. SEL DRIVE current selection
switch.
(
)
S4 is the one for the X-axis, and S8 is the one for the Y-axis.
S5, S9
These are STEP SEL STEP ANGLE selection
switch.
(
)
S5 is the one for the X-axis, and S9 is the one for the Y-axis.
S6, S10
These are HOLD I. SEL HOLD current selection
switch.
(
)
S6 is the one for the X-axis, and S10 is the one for the Y-axis.
Driver LED
POWER LED Green color
turns on at the time of power on state the X-axis and Y-axis of
(
)
POWER, O.H.A
each axis.
(
)
O.H.A LED Red color
turns on when the driver part overheats and cooling is needed.
(
)
The state of O.H.A can be read from the application by the DALM signal.
(
)
Base installation
These are part that fixes the main unit to the installation base. two places
part
Use the M3 or M4 screw.
Connector for
This is a connector for adjustment of the main unit.
adjustment
Do not connect anything.
This is surface of heat radiation in the driver part.
Set up so that this surface may stick to a metallic panel.
